SureTrack Community Fix: Wet Connector

Real Fixes from the SureTrack® expert information resource are documented issues from actual shop repair records and community discussions. Read on to see how SureTrack can help you correct issues that are not easily diagnosed using OEM information alone. SureTrack is currently available free with the purchase of a current Snap-on® diagnostic software version or in our ShopKey Pro product.


Every technician knows that water in the PCM is not a good thing. So you replace it and you still have issues, what do you do? SureTrack community member juniur had a Chevrolet Aveo that had water in the PCM and a code P2138. They posed the question to the community, and with the help of fellow community member DAG1365 and others, they were able to resolve the issue quickly.

The following Community Fix summarizes the interaction between members of the community that led to the solution.

Vehicle
2011 Chevrolet Aveo LT 1.6L

Title
Reduced power mode, replaced PCM and dried out connector.

Complaint
Customer complains that check engine light is on and vehicle has no power.

Diagnostic Steps Performed/Parts Replaced
Confirmed customer’s complaint. Vehicle is in reduced power mode. Found DTC P2138, Accelerator Pedal Position (APP) 1-2 Correlation.
Performed circuit test and found 5v on APP2 signal wire (circuit shorted to voltage). Inspected PCM end of harness found water in the PCM. Replaced PCM, flashed PCM. Still have same issue and same code. Clipped APP2 signal wire at the PCM I have 1.9v leaving PCM. This circuit should have 0v because it receives input from APP2. APP1 circuit has 0v as it is supposed to, checked that just for reference. Is it possible that another wire to the PCM is shorted and back feeding voltage onto this circuit? if so how would I find it?

Best Answer from Community Member DAG1365
It is possible that APP is shorted but check connectors under dash and left kick panel to make sure no other connectors have bad connections. At one time GM had problems with connectors in kick panel getting water in them and corroding.

Cause
The PCM connector was saturated with water causing voltage to stray to other circuits. Used electronic cleaning spray and compressed air to dry the connector and all is good. Have no idea how the water got into the PCM and the connector

Correction
Replaced PCM and cleaned PCM connector. Vehicle back to full power and code did not return.


SureTrack® adds to the power of ShopKey Pro with an exclusive combination of expert knowledge and detailed parts replacement records, all wrapped in an interactive community. Designed to help automotive shops increase accuracy and efficiency from diagnosis to completed repair, the industry’s most comprehensive repair information resource is just a few clicks away.

Want more? Here’s how you can see more Real Fixes in SureTrack:

About the Author

Nick Taylor

Nick Taylor is the SureTrack Community Administrator and a Senior Applications Specialist at Mitchell 1 with over 25 years of experience with electronic repair data systems. Nick previously worked in the automotive dismantling and engine rebuilding industries.